Magswitch MagJig150 Bundle (2x MagJig150s, 40mm Forstner Bit) coping saw NOTE: ASSEMBLY REQUIRED

NOTE: ASSEMBLY REQUIRED

then use the router plane to shave away material until you have a seamless fit

this kit is where to start

Use the included 30mm Forstner Bit to simply drill a hole in a fixture and place the MagJig in to use for downward pressure clamping

Magswitch MagJig150 Bundle (2x MagJig150s, 40mm Forstner Bit) coping saw NOTE: ASSEMBLY REQUIREDJonathans Hot Take: This is the ultimate addition to any shop jig you need held down on a magnetic surface. Use the included 40mm Forstner Bit to simply drill a hole in a jig, place the MagJig in, and rotate the knob to switch it on for a super solid hold. A single MagJig 150 has 133 pounds of magnetic hold force. Magnetic field turns completely on and off mechanically Does not use an electrical power source Holds flat and round surfaces of steel 3 4"